Stonex R80

R80 adopts up to date automatic prism recognition and positioning technology and has a high accuracy of 0.5”-1”.  

R80 has a distance measurement accuracy of 1 mm + 1 ppm (Prism) and a 1.000 m long-range reflectorless distance measurement. This motorized Total Station runs Windows CE 7.0 operating system and users can choose the software that best meets their needs. It supports also SDK and external control protocol for software development.  

R80 OnePole Solution can be managed by switching from a TS to GPS method in a single solution thanks to Cube-a Software which is able to control every part of the survey.

OnePole Solution | TS+GPS with Cube-a Software    

OnePole Solution combines the millimeter positioning accuracy of a prism measurement with the advantage of measuring points not visible from the TS through the GPS Receiver. A total station needs local control points on which it can be set. These points must be visible from the station and therefore the line of sight has to be free of obstacles. An RTK GPS receiver can determine its position in seconds with centimeter level accuracy using data from satellites. The ability to combine and use both systems simultaneously greatly improves surveying efficiency.

Advantages of the system:

•    The OnePole Solution allows you to work simultaneously with TS and GPS

•    TS and GPS (and diastimeter) can be simultaneously connected to the controller using Bluetooth

•    Change the measurement mode from TS to GPS by one simple tap on the always accessible switch button

•    Reduce prism search times through auto aiming to the current GPS position

•    Easily setup your TS position by Station On Point and  Free Station/Resection programs

•    View on Google Maps your TS and GPS surveys

Cube-h²⁴ Solution

Cube-h24 has been designed to perform operations to check movements of points in natural places or artificial structures, considered to be at risk of stability. In general, the materialization of the points is made with prisms used for topography, in order to determine the real distances from a station point. It is however possible to use points marked on a reflecting surface.

Cube-h24 allows to:

• Set up surveys and calculation procedures, in order to compare the coordinates of the points subject to control in subsequent interventions

• Check either in real time or in scheduled time the displacements of the points